Default Outbound Wan/Wwan Ports - Digi Connect IT 4 User Manual

Hide thumbs Also See for Connect IT 4:

Table of Contents

3. Click Network > Interfaces.

4. Click the menu icon (...) next to the name of the WAN or WWAN to be deleted and select Delete.

5. Click Apply to save the configuration and apply the change.

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the

Connect IT 4 local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Use the del command to delete the WAN or WWAN. For example, to delete a WWAN named my_

(config)> del network interface my_wwan

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Default outbound WAN/WWAN ports

The following table lists the default outbound network communications for Connect IT 4 WAN/WWAN

Digi Remote Manager connection to edp12.devicecloud.com .

NTP date/time sync to time.devicecloud.com .

DNS resolution using WAN-provided DNS servers.

HTTPS for modem firmware downloads from

firmware.devicecloud.com .

Digi Connect IT® 4 User Guide

Wide Area Networks (WANs)