1.4.5
10/100/1000 Ethernet Port (RJ45)
ETH0
Function: 10/100/1000 Base-T, auto-sensing LAN connection for NTP/SNTP and remote
management and configuration, monitoring, diagnostics and upgrade
Connector: RJ45, Network IEEE 802.3
1.4.6
10/100/1000 Ethernet Port (SFP)
ETH1
Function: 10/100/1000 (speed depends on connection) Base-T, auto-sensing LAN con-
nection for NTP/SNTP and remote management and configuration, monitoring, dia-
gnostics and upgrade
Connector: Ethernet via SFP
1.4.7
RS-232 Serial Port (Rear Panel)
Function: Accepts commands to locally configure the IP network parameters via CLI for
initial unit configuration.
Connector: RJ45
Character structure: ASCII, 115200 baud, 1 start, 8 data, 1 stop, no parity
1.4.8
USB Serial Port (Front Panel)
Function: Accepts commands to locally configure the IP network parameters via CLI for
initial unit configuration.
Connector: micro-B USB (requires installed driver; if your driver does not automatically
install, visit: https://www.ftdichip.com/Drivers/VCP.htm)
Character structure: ASCII, 115200 baud, 1 start, 8 data, 1 stop, no parity
1.4.9
Input Power
AC power source:
DC power source (option):
Maximum power draw:
SecureSync 2400 Getting Started Guide Rev. 4
100 to 240 V
, ±10 %, 50/60 Hz
AC
12-17 V
-15%, +20%, or
DC
21-60 V
-15%, +20%, secure locking device
DC
1.4 Interfaces
13