Reset Via Front Panel Lcd Screen; Reset Via Front Panel Controls; Rest Via The Cli - Safran WR-ZEN Series User Manual

8.4 Factory Config Mode
8.4.1

Reset via Front Panel LCD Screen

Using the LCD screen, press the info/ctrl button.
Access the following path: Management > Factory Reset.
8.4.2

Reset via Front Panel Controls

1. Reboot the WRZ device.
2. Press the CTRL/Info button more than 15s while Uboot is loading.
3. Hold until a reset factory message appears on LCD.
4. Wait until the device reboot with default factory parameters.
8.4.3

Rest via the CLI

To perform a CLI Factory Reset, serial access is required.
Execute a power cycle. Once the unit is just powered on, press the Reset button
on the front panel (use a thin tool) until the following message displays in the CLI:
I n t h e C L I :
U-Boot 2015.04-wr7s-v2.10-z16 (Apr 26 2022 - 10:51:49) Z16v4
WR_Z16-v4.1-S01_183
Environment found in flash
CTRL button is pressed!
...................
Setting reset factory boot mode
To complete the factory reset, hold the Reset button for 20s.
178
Note: The factory config mode does not revert the device to its fact-
ory firmware. It only removes all the configurations and cus-
tomizations stored by the user and will reboot the device using a
clean version of the last firmware flashed.
Note: Performing a factory reset erases IP address configuration, so
serial access is mandatory to reconfigure remote access (web and
SSH communication).
CHAPTER •
8 WR-ZEN Series User Manual Rev. v5.1