Default Configuration; Connecting To The Device; Necessary Items For Connectivity; Logging From The Uart - Safran WR-ZEN Series User Manual

3.1 Default Configuration
3.1

Default Configuration

The device is factory configured with the following default settings:
Table 3-1:
eth0
eth1
Timing Preset
HTTPS
SSH/web credentials
The device credentials can be configured as needed. Learn more in
Authentication" on
3.2

Connecting to the Device

There are two ways to connect to the WR-ZEN device using the terminal:
This section will first introduce the general concepts on how to log to the device
and then it will provide the specific steps, depending on the user OS.
3.2.1

Necessary Items for Connectivity

These are the required cables and adapters:
3.2.2

Logging from the UART

In order to connect to the WR-ZEN device, it is required to connect the RJ45-
RS232(m) and RS232(f)-USB cable to the RJ45 management port at the front
panel.
26
Default Factory Settings
Port/ Service
page 111.
Via UART
Via SSH
RJ-45 Cat5/6/7 Ethernet cable.
RJ45-RS232(m) and RS232(f)-USB cable.
Default Value
Waits for DHCP offer
192.168.77.100
Slave on WRO (BC)
WR master on all other ports
Disabled
user:
password: root
CHAPTER •
3 WR-ZEN Series User Manual Rev. v5.1
root
"Security &