Rebooting The System; Notifications - Safran VersaSync User Manual

Once you have halted your VersaSync, power must be removed (unplugged) and
reapplied in order to restart the unit.
4.2

Rebooting the System

To reboot VersaSync via the Web UI:
Rebooting via USB Port, Telnet, SSH, SNMP
With a serial connection to the USB port, telnet connection or SSH connection,
type reboot <Enter> to reboot VersaSync.
Reboot is also is available to be performed through an snmpset operation. For
more information on VersaSync commands, see
4.3

Notifications

If an event occurs e.g., VersaSync transitions into Holdover, or a short is detected
in the GNSS antenna, VersaSync can automatically notify users that a specific
event has occurred.
In some situations, two events are generated. One event occurs in the transition
to a specified state and then another event occurs when transitioning back to the
original state. Examples of these are losing sync and then regaining sync, or
going into Holdover mode and then going out of Holdover mode. Other situ-
ations may only consist of one event. An example of this situation is switching
from one input reference to another.
Notifications of each event that may occur can be via alarms, via SNMP Traps
being sent to one or more SNMP Managers, via an email being sent to a specified
email recipient, or a combination of the three. The Notifications page allows a
user to configure whether the occurrence of each event automatically triggers an
CHAPTER •
4 VersaSync User Manual Rev. 12
1. Navigate to TOOLS > SYSTEM:
2. Select the Restart after Shutdown
3. VersaSync will now be rebooted and be accessible again shortly thereafter.
4.2 Rebooting the System
Reboot/Halt.
box in the Reboot/Halt
"CLI Commands" on
window.
page 313.
233