Ntp Provider; Ntp Over Fiber Optics (Wrx Ports) - Safran WR-Z16 User Manual

5.6 NTP
5.6.1.1

NTP Provider

The WRZ- OS allow the device to provide its time through NTP on the man-
agement interfaces using the following parameters:
OID
3.7005.x
3.7005.1
3.7005.4
3.7005.7
5.6.1.2

NTP over Fiber Optics (wrX ports)

To configure an NTP server over a fiber optics port, set the particular wrX port
protocol as NTP (see
set).
The NTP Stratum can be configured using the table in the previous section.
88
Name Value Type
ntp/cfg/provider/xxx
Enabled <Boolean>
• YES
• NO
Stratum Mode • Manual
Manual • Stratum 1
Stratum • Stratum 2
• Stratum 3
• Stratum 4
• Stratum 15
Caution:
Reboot to apply NTP provider parameter: Many of the set-
tings to configure the NTP server are only loaded during initialization
of the device and thus a reboot might be needed in order to apply
them.
"Custom" on page 62
Caution: NTP time is distributed over UDP and thus it requires the
interface to have an IP and subnet configured on the subnet where
NTP is going to be served.
Description
Configuration on how to provides
NTP to 3rd party devices.
If 'Yes' the device will act as an NTP server
on its management interfaces to distribute
its own Time of Day to other devices.
Mode to provide the NTP stratum. If Manual
it will directly set the value from 'Manual
Stratum', otherwise it will take into account
the virtual clock quality (timing source,
clock accuracy, etc.) to modify this value.
Manually force the Stratum announced by
"Stratum Levels" on
the NTP server. See
page 90
for more information
for information on the Custom Pre-
CHAPTER •
5 WR-Z16 User Manual Rev. v5.0
.