Default
The default setting is 4294967295.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
limit: Sets the maximum number of multicast groups that a port can join, in the range of 0 to
4294967295.
vlan vlan-list: Specifies a space-separated list of up to ten VLAN items. Each item specifies a VLAN by
its ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The VLAN ID is in the range of 1 to
4094. If this option is not specified, this command takes effect for all VLANs..
Usage guidelines
This command is effective on the IPv6 multicast groups that a port dynamically joins. If you configure the
port as a static member port for an IPv6 multicast group, this command is not effective on the IPv6
multicast group.
Examples
# Set the maximum number of IPv6 multicast groups that Ten-GigabitEthernet 1/1/5 in VLAN 2 can join
to 10.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] mld-snooping group-limit 10 vlan 2
mld-snooping group-policy
Use mld-snooping group-policy to configure an IPv6 multicast group filter on a port to control the IPv6
multicast groups that the hosts on the port can join.
Use undo mld-snooping group-policy to remove the IPv6 multicast group filter on a port.
Syntax
mld-snooping group-policy acl6-number [ vlan vlan-list ]
undo mld-snooping group-policy [ vlan vlan-list ]
Default
No IPv6 multicast group filter is configured on a port. Namely, the hosts attached to the port can join any
valid IPv6 multicast group.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
acl6-number: Specifies a basic or advanced IPv6 ACL by its number, in the range of 2000 to 3999. A
host can join only the IPv6 multicast groups that match the permit statement in the specified ACL. The
111