Safety; Conventions; Safety Precautions - Epson RC520 Manual

1. Safety

Installation and transportation of robots and robotic equipment shall be performed by
qualified personnel and should conform to all national and local codes.
Please read this manual and other related manuals before installing the robot system or
before connecting cables. Keep this manual handy for easy access at all times.
Please read the Safety chapter in User's Guide to understand safety requirements before
installing the robot system.
EPSON RC+ :User's Guide - chapter Safety
SPEL CT

1.1 Conventions

Important safety considerations are indicated throughout the manual by the following
symbols. Be sure to read the descriptions shown with each symbol.

1.2 Safety Precautions

Only trained personnel should design and install the robot system.
Trained personnel are defined as those who have taken robot system training and
maintenance training classes held by the manufacturer, dealer, or local representative
company, or those who understand the manuals thoroughly and have the same knowledge
and skill level as those who have completed the training courses.
The following items are safety precautions for qualified design or installation
p ersonnel:
■ Personnel who design and/or construct the robot system with this product must
read the Safety chapter in User's Guide to understand the safety requirements
before designing and/or constructing the robot system.
constructing the robot system without understanding the safety requirements is
extremely hazardous, may result in serious bodily injury and/or severe
WARNING
equipment damage to the robot system, and may cause serious safety
problems.
RC520 Rev.7
:User's Guide Introduction
:Safety - 1. Safety and 2. Basic Safety-related Matters
This symbol indicates that a danger of possible serious injury or
death exists if the associated instructions are not followed
properly.
WARNING
This symbol indicates that a danger of possible harm to people
caused by electric shock exists if the associated instructions are
not followed properly.
WARNING
This symbol indicates that a danger of possible harm to people
or physical damage to equipment and facilities exists if the
associated instructions are not followed properly.
CAUTION
Setup & Operation 1. Safety
Designing and/or
3