How To Edit The Alarm Information; Alarm Notifying Method - Epson RC90 Manual

Maintenance 6. Alarm
NOTE


6.3 How to Edit the Alarm Information

The configured alarm information can be edited in the EPSON RC+ 7.0.
(1) Select EPSON RC+ 7.0 menu-[Tools]-[Maintenance] to display the [Controller
(2) Select the alarm to be changed and click the <Change> button.
(3) Display the [Change Alarm] dialog box and enter any of the followings.
(4) Click the <OK> button and change the specified alarm information.

6.4 Alarm Notifying Method

The alarm notifying method needs to be configured by the output bit of the Remote I/O.
The Remote I/O can be configured in the EPSON RC+ 7.0- [Setup] - [System
Configuration] - [Controller] - [Remote Control].
For details, refer to the EPSON RC+ 7.0 User's Guide 12.1 Remote I/O.
NOTE

The controller does not enter the error or warning state even if an alarm occurs.
98
There are three states of the alarm.
Display
OK An alarm is configured. An alarm is not occurring.
Expired An alarm is occurring. Replacement is required.
Not set An alarm is not configured.
Tools] dialog box.
Purchase or replacement date of the battery
Date of grease up
Status
RC90 (EPSON RC+ 7.0) Rev.8