Toyota Camry Manual page 91

AX1–18
AUTOMATIC TRANSAXLE –
THROTTLE CABLE INSTALLATION
1. INSTALL CABLE IN TRANSAXLE CASE
(a) Be sure to push it in all the way.
(b) Install the retaining plate and the bolt.
2. INSTALL VALVE BODY
(See page AX–15)
3. IF THROTTLE CABLE IS NEW, STAKE STOPPER ON
INNER CABLE
(a) Bend the cable so there is a radius of about 200 mm
(7.87 in.).
(b) Pull the inner cable lightly until a slight resistance is
felt, and hold it.
(c) Stake the stopper 0.8–1.5 mm (0.031–0.059 in.)
from the end of outer cable, as shown.
4. CONNECT THROTTLE CABLE
(a) Connect the cable to the throttle linkage.
(b) Connect the cable housing to the bracket.
5. ADJUST THROTTLE CABLE
(See page AX1–55)
6. INSTALL PARK/NEUTRAL POSITION SWITCH
(a) Install the park/neutral position switch.
(b) Install the manual shift lever.
(c) Adjust the park/neutral position switch.
(See page AX1–56)
(d) Connect the transaxle control cable.
ON–VEHICLE REPAIR