BR–16
BRAKE SYSTEM
–
MASTER CYLINDER
4. INSTALL 2 GROMMETS
5. INSTALL RESERVOIR
(a) Install the strainer and cap to the reservoir.
(b) Push the reservoir onto the cylinder.
(c) Install the set screw while pushing on the reservoir.
Torque: 1.7 N–m (17.5 kgf–cm, 15.2 in.–lbf)
6. INSTALL MASTER CYLINDER BOOT
Facing the UP mark on the master cylinder boot up–
wards, install the cylinder boot to the master cylinder.
MASTER CYLINDER INSTALLATION
1. ADJUST LENGTH OF BRAKE BOOSTER PUSH ROD
BEFORE INSTALLING MASTER CYLINDER
(See page BR–19)
2. INSTALL MASTER CYLINDER
Install the master cylinder and a new gasket on the
brake booster with 3 nuts.
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf)