Toyota Camry Manual page 614

Hide thumbs Also See for Camry:

WINDSHIELD MOULDING

3. REMOVE WINDOWSHIELD UPPER MOULDING

(a) Insert the top of scraper between the body and the

HINT: Tape the scraper tip before use.

(b) Pry up the scraper to loosen the moulding from the

claws of the clips and retainers.

FASTENER REPLACEMENT

REPLACE FASTENER

(a) Remove the damaged fastener.

(b) Cut off the old adhesive around the fastener installa–

HINT: Be careful not to damage the body.

(d) Install a new fastener onto the body.

WINDSHIELD MOULDING INSTALLATION

1. INSTALL NEW CLIP INTO MOULDING

Install the clip to the appropriate place on the mould–

ing, where the clip would engage with the fastener.

2. APPLY ADHESIVE AT NEW CLIP INSTALLATION

(a) When the clip being engaged with the moulding is

removed, cut out the old adhesive around the clip

installation area.

NOTICE: Do not damage the body and fastener.

(b) Apply adhesive at the clip installation area so water

does not collect there.

3. INSTALL WINDSHIELD UPPER MOULDING

(a) Place the moulding onto the body.

(b) Tap the moulding with your hand to fasten the clips at

the glassedge.

At the same time, install the fastener, by tapping them

4. INSTALL WINDSHIELD OUTSIDE MOULDING

5. INSTALL WEATHERSTRIP