Toyota Camry Manual page 43

AIR CONDITIONING SYSTEM
(c) Using SST and torque wrench, fasten the magnet
clutch lead wire to the cylinder block.
Torque: 3.4 N–m (35 kgf.cm, 30 in.–lbf)
SST 07110–61050
2. INSTALL ROTOR
(a) Install the rotor on the compressor shaft.
(b) Using SST, install the new snap ring.
SST 07114–84020
CAUTION:Do not spread the point of SST widely.
Max width:
NOTICE: The snap ring should be installed so that its
beveled side faces up.
3. INSTALL PRESSURE PLATE
(a) Put the shims on the pressure plate.
(b) Using SST and torque wrench, install the shaft bolt.
SST 07112–76060
Torque: 13 N–m (135 kgf–cm, 10 ft–lbf)
– COMPRESSOR
23.1 mm
AC–43