BR–286
INSPECTION PROCEDURE
Check ABS actuator solenoid.
Check for open and short in harness and connector between ABS ECU and
actuator (See page
If the same code is still output after the diagnostic trouble code is deleted, check the contact condition of each
connection.
If the connections are normal, the ECU may be defective.
BRAKE SYSTEM
–
Disconnect the 2 connectors from ABS actuator.
Check continuity between terminals A5 4and A4
1, 3, 4, 6 of ABS actuator connector.
Continuity
HINT: Resistance of each solenoid coil is 1.2
IN–28
).
ANTI–LOCK BRAKE SYSTEM (ABS)
Replace ABS actuator.
Repair or replace harness or connector.
W
.