Toyota Camry Manual page 392

Tester connection to
terminal number
BODY ELECTRICAL SYSTEM
LIGHT FAILURE SENSOR INSPECTION
INSPECT LIGHT FAILURE SENSOR
Relay Circuit
Disconnect the connector from the sensor and in–
spect the connector on the wire harness side, as
shown.
Condition
Constant
Constant
Constant
Constant
Condition
Light control switch position OFF
Light control switch position TAIL or HEAD
Engine condition Stop
Engine condition Running
Ignition switch position LOCK or ACC
Ignition switch position ON
Stop light switch position OFF
Stop light switch position ON
*: There is resistance because this circuit is grounded
through the bulb.
If circuit is as specified, replace the sensor. If the
circuit is not as specified, inspect the circuits connect–
ed to other parts.
– COMBINATION METER
Specified value (Continuity)
* Continuity
* Continuity
* Continuity
Continuity
No voltage
Battery positive voltage
No voltage
Battery positive voltage
No voltage
Battery positive voltage
No voltage
Battery positive voltage
Specified value (Voltage)
BE–73