Toyota Camry Manual page 110

Terminal
Connector
AUTOMATIC TRANSAXLE –
ELECTRIC CONTROL COMPONENTS
INSPECTION
1. INSPECT SHIFT LOCK CONTROL ECU
Using a voltmeter, measure the voltage at each termi–
nals.
HINT: Do not disconnect the ECU connector.
Measuring condition
Ignition switch ACC position
Ignition switch ON position
Depress brake pedal
Ignition switch ACC position and P position
Ignition switch ACC position and except P position
Ignition switch ON position and P position
Depress brake pedal
Except P position
Ignition switch ON, P position and depress brake pedal
Shift except P position under conditions above
Ignition switch ACC position and P position
Shift except P position under condition above
2. INSPECT SHIFT LOCK SOLENOID
(a) Disconnect the solenoid connector.
(b) Using an ohmmeter, measure the resistance between
terminals.
Standard resistance:
21–27W
(c) Apply the battery positive voltage between terminals.
Check that an operation noise can be heard from the
solenoid.
SHIFT LOCK SYSTEM
(Approx–after 1 second)
(Approx–after 20 seconds)
AX1–37
Voltage (V)