BR–132
INSPECTION PROCEDURE
Check ABS warning light.
See Combination Meter Troubleshooting on page
Check ABS control relay.
Check for open in harness and connector between DLC1 and A6S control relay and body ground
(See page IN–27).
BRAKE SYSTEM
–
ANTI–LOCK BRAKE SYSTEM (ABS)
BE–1
18.
Replace bulb or combination meter assembly.
Disconnect the connectors from control relay.
Check continuity between each terminal of ABS
control relay.
Terminals
Terminals
Terminals
1. Apply battery positive voltage between termi–
nals A7 1 and A6 3.
2. Check continuity between each terminal of
ABS control relay.
Terminals
Terminals
Connect the
the
between the terminals.
Continuity
If there is no continuity, connect the
terminal 4 of
of A7 . Recheck continuity between terminals.
Replace ABS control relay.
Continuity (Reference
1 and
value 80W)
5 and
2 and
5 and
2 and
test lead to terminal 4 of A7 and
lead to terminal 5 of A7 . Check continuity
A7 and the
lead to terminal 5
Continuity
Open
Open
Continuity
test lead to