Toyota Camry Manual page 709

BRAKE SYSTEM – FRONT BRAKE(Single–Piston Type)
6. INSTALL PAD SUPPORT PLATES
Install the 4 pad support plates.
7. INSTALL NEW PADS
(a) 1 MZ–FE engine:
Install a pad wear indicator plate on the inside pad.
(b) Apply disc brake grease to both sides of the inner anti
–squeal shim.
(c) Install the 2 anti–squeal shims on each pad.
(d) install inside pad with the pad wear indicator plate
facing upward.
(e) Install outside pad.
NOTICE: There should be no oil or grease adhering to the
friction surfaces of the pads or the disc.
(f) Install the 2 anti–squeal springs.
8. INSTALL CALIPER
(a) Draw out a small amount of brake fluid from the
reservoir.
(b) Press in the piston with water pump pliers or similar
implement.
HINT: If the piston is difficult to push in, loosen the
bleeder plug and push in the piston while letting some
brake fluid escape.
BR–23