Toyota Camry Manual page 89

AX1–16
AUTOMATIC TRANSAXLE –
(d) Place the detent spring on the manual valve body and
hand tighten the 2 bolts first.
Then, tighten them with a torque wrench.
(e) Check that the manual valve lever is touching the
center of the detent spring tip roller.
6. INSTALL OIL TUBES
Tap the tubes with a plastic hammer to install them
into the positions indicated in the illustration.
NOTICE: Be careful not to bend or damage the tubes.
7. INSTALL OIL STRAINER AND APPLY TUBE BRACK–
ET
(a) Install the oil strainer and torque the 3 bolts.
(b) Install the apply tube bracket and the 2 bolts.
Torque: 10 N–m (100 kgf–cm, 7s. ft–lbf)
8. INSTALL MAGNETS IN PAN
Install the 2 magnets in the indentations of the pan.
9. INSTALL OIL PAN WITH NEW GASKET
NOTICE: Make sure that the magnet does not interfere
with the oil tubes.
Torque: 4.9 N–m (50 kgf–cm, 43 in.–Ibf)
10. INSTALL DRAIN PLUG WITH NEW GASKET
Using SST, install the drain plug with a new gasket
and tighten it.
Torque: 49 N–m (500 kgf–cm, 36 ft–lbf)
SST 09043–38100
ON–VEHICLE REPAIR
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)