Toyota Camry Manual page 322

BODY ELECTRICAL SYSTEM
HOW TO REPLACE TERMINAL
(with terminal retainer or secondary locking device)
1. PREPARE THE SPECIAL TOOL
HINT: To remove the terminal from the connector,
please construct and use the special tool or like object
shown on the left.
2. DISCONNECT CONNECTOR
3. DISENGAGE THE SECONDARY LOCKING DEVICE
OR TERMINAL RETAINER
(a) Locking device must be disengaged before the termi–
nal locking clip can be released and the terminal re–
moved from the connector.
(b) Use a special tool or the terminal pick to unlock the
secondary locking device or terminal retainer.
NOTICE: Do not remove the terminal retainer from con–
nector body.
(c) Release the locking lug from terminal and pull the
terminal out from rear.
4. INSTALL TERMINAL TO CONNECTOR
(a) Insert the terminal.
HINT:
1. Make sure the terminal is positioned correctly.
2. Insert the terminal until the locking lug locks firmly.
3. Insert the terminal with terminal retainer in the
temporary lock position.
(b) Push the secondary locking device or terminal retainer
in to the full lock position.
5. CONNECT CONNECTOR
– GENERAL INFORMATION
BE–3