Toyota Camry Manual page 475

BE–156
Tester connection to
terminal number
2 – Ground
3 – Ground
3 – Ground
4 – Ground
4 – Ground
5 – Ground
5 – Ground
6 – Ground
6 – Ground
BODY ELECTRICAL SYSTEM
2. INSTALL ANTENNA ROD
(a) Insert the cable of the rod until it reaches the bottom.
HINT:
When inserting the cable, the teeth on the cable
must face toward the rear of the vehicle.
Insert the cable approx. 400 mm (15.7 in.).
(b) Wind the cable to retract the rod by turning the
ignition switch to "LOCK" position.
HINT:
If the ignition switch is already in "LOCK" posi–
tion, perform step 1 (c) first, then turn the ignition
switch to "ACC" position.
In case the cable is not wound, twist it, as shown
in the illustration.
Even if the rod has not retracted fully, install the
antenna nut and inspect the antenna rod opera–
tion. It will finally retract fully.
(c) Inspect the antenna rod operation by pushing the
radio wave band select buttons.
MOTOR ANTENNA INSPECTION
1. INSPECT MOTOR ANTENNA
Circuit
Disconnect the motor antenna connector from the
body wire harness and inspect the connector on body
wire harness side, as shown.
Condition
Constant
Ignition switch ACC or ON and radio switch
ON Others
Ignition switch ACC or ON and radio switch
ON AM or FM (87.9 – 96.0 MHz)
Ignition switch ACC or ON Radio switch
OFF
Ignition switch ACC or ON Radio switch ON
Ignition switch position ACC or LOCK
Ignition switch position ON
Ignition switch position LOCK
Ignition switch position ACC or ON
– AUDIO SYSTEM
Battery positive voltage
No voltage
Battery positive voltage
No voltage
Battery positive voltage
No voltage
Battery positive voltage
No voltage
Battery positive voltage
Specified value (Voltage)