Toyota Camry Manual page 88

AUTOMATIC TRANSAXLE –
VALVE BODY INSTALLATION
1. INSTALL SECOND BRAKE APPLY GASKET
2. INSTALL VALVE BODY
(a) While holding the cam down with your hand, slip the
cable and into the slot.
(b) Bring valve body into place.
NOTICE: Be careful not to entangle the solenoid wire.
3. INSTALL BOLTS IN VALVE BODY
Hand tighten the 12 bolts first, then torque with a
torque wrench.
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)
Bolt length:
A 20 mm (0.79 in.)
B 25 mm (0.98 in.)
C 36 mm (1.42 in.)
D50mm(1.97in.)
4. CONNECT SOLENOID WIRING
(a) Connect the shift solenoid valve No. 1 connector
(white and shorter wire).
(b) Connect the shift solenoid valve No. 2 connector
(black and longer wire).
5. INSTALL MANUAL VALVE BODY DETENT SPRING
(a) Align the manual valve with the pin on the manual
shaft lever.
(b) Lower the manual valve body into place.
(c) Hand tighten the 4 bolts first. Then, tighten them with
a torque wrench.
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)
ON–VEHICLE REPAIR
AX1–15