Toyota Camry Manual page 134

HYDRAULIC TEST
MEASURE LINE PRESSURE
NOTICE:
Perform the test at normal operating fluid temperature 50–80 _C (122–176 _F).
The line, pressure test should always be carried out in pairs. One technician should observe the
conditions of the wheels or wheel stoppers outside the vehicle while the other is performing the
test.
(a) Warm up the transaxle fluid.
(b) Remove the test plug on the transaxle case left side and connect the oil pressure gauge SST.
SST 09992–00094
(c) Fully apply the parking brake and chock the 4 wheels.
(d) Start the engine and check idling RPM.
(e) Keep your left foot pressed firmly on the brake pedal and shift into D position.
(f)' Measure the line pressure when the engine is idling.
(g) Fully depress the accelerator pedal. Quickly read the highest line pressure when engine speed
reaches stall speed.
(h) In the same manner, perform the test in R position.
SPECIFIED LINE PRESSURE
Line pressure
Idling
Stall
If the measured pressures are not up to specified values, recheck the throttle cable adjustment
and retest.
AUTOMATIC TRANSAXLE –
kPa (kgf/emt, psi)
D position
362–422 (3.7–4.3, 53–61)
750–897 (7.7–9.2,109–130)
TROUBLESHOOTING
R position
618–794 (6.3–8.1,90–115)
1,373–1,608 (14.0–16.4,199–233)
AX1–61
kPa (kgf/cmt, psi)