Toyota Camry Manual page 533

BE–214
INSPECTION PROCEDURE
Check operation of overdrive.
Test drive after engine warm up.
Check that overdrive ON H OFF occurs with operation of OD switch ON–OFF.
Check voltage between terminal OD of harness side connector of cruise
control ECU and body ground.
Go to step
BODY ELECTRICAL SYSTEM – CRUISE CONTROL SYSTEM
Check and Repair Electronically Con-
trolled Transaxle (See page AX Section).
Remove cruise control ECU with connectors still
connected.
1. Disconnect cruise control ECU connector.
2. Turn ignition switch ON.
3. Measure voltage between terminal OD of
harness side connector of cruise control ECU
and body ground.
Voltage: 10 – 14 V
Go to step