Toyota Camry Manual page 130

MECHANICAL SYSTEM TESTS
STALL TEST
The object of this test is to check the overall performance of the transaxle and engine by
measuring the stall speeds in the D and R positions.
NOTICE:
Perform the test at normal operating fluid temperature 50–80
Do not continuously run this test longer than 5 seconds.
To ensure safety, conduct this test in a wide, clear, level area which provides good traction.
The stall test should always be carried out in pairs. One technician should observe the conditions
of the wheels or wheel stoppers outside the vehicle while the other is performing the test.
MEASURE STALL SPEED
(a) Chock the 4 wheels.
(b) Connect a tachometer to the engine.
(c) Fully apply the parking brake.
(d) Keep your left foot pressed firmly on the brake pedal.
(e) Start the engine.
(f) Shift into the D position. Fully depress the accelerator pedal with your right foot.
Quickly read the stall speed.
Stall speed:
2,450 150 rpm
(g) Perform the same test in R position.
Quickly read the stall speed.
Stall speed:
2,450 150 rpm
AUTOMATIC TRANSAXLE – TROUBLESHOOTING
_
C (122–176
AX1–57
_
F).