Toyota Camry Manual page 710

BR–24
BRAKE SYSTEM – FRONT BRAKE(Single–Piston Type)
(c) Install the caliper.
(d) Hold the sliding pin and torque the installation bolt.
Torque: 34 N–m (350 kgf–cm, 25 ft–lbf)
9. INSTALL FRONT WHEEL
10. CHECK THAT FLUID LEVEL IS AT MAX LINE
CALIPER REMOVAL
1. DISCONNECT FLEXIBLE HOSE
(a) Remove the union bolt and 2 gaskets from the caliper,
then disconnect the flexible hose from the caliper.
(b) Use a container to catch the brake fluid as it drains
out.
2. REMOVE CALIPER
(a) Hold the sliding pin and loosen the 2 installation bolts.
(b) Remove the 2 installation bolts.
(c) Remove the caliper from the torque plate.
3. REMOVE 2 BRAKE PADS
Remove the inside and outside pads.
CALIPER DISASSEMBLY
1. REMOVE CYLINDER BOOT SET RING AND CYLIN–
DER BOOT
Using a screwdriver, remove the cylinder boot set ring
and cylinder boot from the caliper.