Toyota Camry Manual page 418

Tester connection to
terminal number
14 – Ground
14– Ground
16 – Ground
Tester connection to
terminal number
1 – Ground
1 – Ground
8 – Ground
BODY ELECTRICAL SYSTEM
Condition
Passenger's door courtesy switch position
OFF (Door closed)
Passenger's door courtesy switch position
ON (Door opened)
Constant
Condition
Ignition switch position LOCK or ACC
Ignition switch position ON
Constant
If circuit is as specified, inspect the door lock signal.
If the circuit is not as specified, inspect the circuits
connected to other parts.
DOOR LOCK SIGNAL
HINT: When the relay circuit is as specified, inspect
the door lock signal.
(a) Connect the connector to the relay.
(b) Connect the positive (+) lead from the voltmeter to
terminal 3 and the negative (–) lead to terminal 4.
(c) Set the door lock manual switch to UNLOCK, check
that the voltage rises from 0 volts to battery positive
voltage for approximately 0.2 seconds.
(d) Reverse the polarity of the voltmeter leads.
(e) Set the door lock manual switch to LOCK, check that
the voltage rises from 0 volts to battery positive
voltage for approximately 0.2 seconds.
If operation is not as specified, replace the relay.
– POWER DOOR LOCK CONTROL SYSTEM
Specified value (Continuity)
No continuity
Continuity
Continuity
No voltage
Battery positive voltage
Battery positive voltage
Specified value (Voltage)
BE–99