Toyota Camry Manual page 423

BE–104
Tester connection to
terminal number
BODY ELECTRICAL SYSTEM
(b) With the sliding roof in fully opened position, hold the
sliding roof switch in "CLOSE" position and check that
the sliding roof begins to close within 60 seconds.
If operation is not as specified, replace the motor.
SLIDING ROOF CONTROL RELAY
INSPECTION
INSPECT SLIDING ROOF CONTROL RELAY
Circuit
Disconnect the connector from the relay and inspect
the connector on the wire harness side, as shown in
the chart.
Condition
Sliding roof control switch position (SLIDE)
OFF or CLOSE
Sliding roof control switch position (SLIDE)
OPEN
Sliding roof control switch position (SLIDE)
OFF or OPEN
Sliding roof control switch position (SLIDE)
CLOSE
Sliding roof control switch position (TILT)
OFF or DOWN
Sliding roof control switch position (TILT)
UP
Constant
Constant
Constant
Sliding roof control switch position (TILT)
OFF or UP
Sliding roof control switch position (TILT)
DOWN
No. 1 limit switch position OFF (Sliding roof
tilted up or open approx. 200 mm (7.87in.))
No. 1 limit switch position ON (Except for
conditions mentioned above)
No. 2 limit switch position OFF (Sliding roof
closed)
No. 2 limit switch position ON (Sliding roof
open)
– SLIDING ROOF SYSTEM
Specified value (Continuity)
No continuity
Continuity
No continuity
Continuity
No continuity
Continuity
No continuity
Continuity
No continuity
No continuity
Continuity
No continuity
Continuity
No continuity
Continuity