Toyota Camry Manual page 904

Hide thumbs Also See for Camry:

BRAKE SYSTEM

REAR BRAKE(Disc Brake)

2. MEASURE DISC THICKNESS

Using a micrometer, measure the disc thickness.

Standard thickness:

10.0 mm (0.394 in.)

Minimum thickness:

9.0 mm (0.354 in.)

Replace the disc if the disc's thickness is at the mini–

mum thickness or less. Replace the disc or grind it on

a lathe if it is badly scored or worn unevenly.

3. MEASURE DISC RUNOUT

Measure the disc runout 10 mm (0.39 in.) from the

outer edge of the disc.

Maximum disc runout:

0.15 mm (0.0059 in.)

If the runout is greater than the maximum, replace the

HINT: Before measuring the runout, confirm that the

hub bearing play is within specification.

4. IF NECESSARY, REPLACE DISC

(a) Remove the torque plate.

(b) Remove the hub nuts of the temporarily installed disc

and pull off the disc.

(d) Install the torque plate and tighten the mounting

Torque: 47 N–m (475 kgf–cm, 34 ft–lbf)

CALIPER ASSEMBLY

1. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO

PARTS INDICATED WITH ARROWS

2. INSTALL PISTON SEAL AND PISTON IN CYLINDER