Toyota Camry Manual page 477

BE–158
Tester connection to
terminal number
1–4
2 – Ground
Tester connection to
terminal number
3 – Ground
5 – Ground
5 – Ground
6 – Ground
6 – Ground
6 – Ground
8 – Ground
8 – Ground
8 – Ground
9 – Ground
9 – Ground
BODY ELECTRICAL SYSTEM
3. INSPECT ANTENNA MOTOR CONTROL RELAY
Relay Circuit
Disconnect the connector from the relay and inspect
the connector on wire harness side, as shown in the
chart.
Condition
Constant
Constant
Condition
Constant
Ignition switch position LOCK
Ignition switch position ACC or ON
Ignition switch position LOCK
Ignition switch position ACC or ON Radio
switch and cassette OFF
Ignition switch position ACC or ON Radio
switch or cassette ON
Ignition switch position LOCK
Ignition switch position ACC or ON Radio
switch OFF or casette ON
Ignition switch position ACC or ON Radio
switch ON and casette OFF
Ignition switch position LOCK or ACC
Ignition switch position ON
If circuit is as specified, replace the relay.
GLASS PRINTED ANTENNA INSPECTION
1. INSPECT GLASS PRINTED ANTENNA
(Use same procedure as for "INSPECT DEFOGGER
WIRES" on page BE–80.)
2. REPAIR GLASS PRINTED ANTENNA
(Use same procedure as for " REPAIR DEFOGGER
WIRES" on page BE–80.)
– AUDIO SYSTEM
Specified value (Continuity)
Continuity
Continuity
Battery positive voltage
No voltage
Battery positive voltage
No voltage
No voltage
Battery positive voltage
No voltage
No voltage
Battery positive voltage
No voltage
Battery positive voltage
Specified value (Voltage)