Toyota Camry Manual page 701

BRAKE SYSTEM – MASTER CYLINDER
MASTER CYLINDER INSPECTION
HINT: Clean the disassembled parts with compressed
air.
1. INSPECT CYLINDER BORE FOR RUST OR SCORING
2. INSPECT CYLINDER FOR WEAR OR DAMAGE
If necessary, clean or replace the cylinder.
MASTER CYLINDER ASSEMBLY
1. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO
RUBBER PARTS INDICATED BY ARROWS
2. INSTALL 2 SPRINGS AND PISTONS
NOTICE: Be careful not to damage the rubber lips on the
pistons.
(a) Install the 2 springs and pistons straight in, not at an
angle.
NOTICE: If install at an angle, there is a possibility of
damaging the cylinder bore.
(b) Push in the piston with a screwdriver and install the
snap ring with snap ring pliers.
HINT: Tape the screwdriver tip before use.
3. INSTALL PISTON STOPPER BOLT
Using a screwdriver, push the piston in all the way and
install the piston stopper bolt over a new gasket.
Torque the bolt.
Torque: 10 N .m (100 kgf–cm, 7 ft–lbf)
BR–15