Toyota Camry Manual page 344

BODY ELECTRICAL SYSTEM
1. REMOVE WIRE HARNESS HOLDER NO.1
2. REMOVE TERMINALS FROM CONNECTOR
(a) Release the 4 tabs and open the terminal cover.
NOTICE: Do not remove terminal for SRS connector
(Yellow).
(b) From the open end, insert a miniature screwdriver
between the locking lug and terminal.
(c) Pry down the locking lug with the screwdriver and pull
the terminal out from the rear.
3. REMOVE WIRE HARNESS HOLDER NO. 2
(a) Remove the clamp.
(b) Pry loose 2 locking lugs.
(c) Remove the 2 screws and the wire harness holder No.
2.
4. REMOVE SPIRAL CABLE SUBASSEMBLY
(a) Disconnect the connector.
(b) Remove the 4 screws and the spiral cable sub–
assembly.
– HEADLIGHT AND TAILLIGHT SYSTEM
BE–25