AX1–104
INSPECTION PROCEDURE
Check 0 /D OFF indicator light when engine starting.
Check O/D main switch operation.
AUTOMATIC TRANSAXLE
–
When starting the engine, check the operating con–
dition of the O/D OFF indicator light.
O/D OFF indicator lights immediately after the
engine is started.
Remains ON..... NG 1
Remains OFF.... NG2
If the O/D OFF indicator light keeps blinking, check
the diag. trouble code and repair the problem.
NG1
NG2
(1) Turn ignition switch ON.
(2) Check–O/D OFF" light when O/D main switch
(3) Start the engine.
"O/D OFF" light goes off.
(3) Check "O/D OFF" light when O/D main switch
"O/D OFF" light lights up.
If the–O/D OFF" light blinks when the O/D main
switch is pushed in to ON, a malfunction is occur–
ing in the system.
Check the diagnostic trouble code.
TROUBLESHOOTING
Go to step
Go to stop
is pushed in to ON.
is pushed again, to OFF.
Proceed to next circuit inspection shown
on matrix chart (See page AX1–68).