Toyota Camry Manual page 937

Hide thumbs Also See for Camry:

BRAKE SYSTEM

ANTI–LOCK BRAKE SYSTEM (ABS)

MAIN POINTS OF DISASSEMBLY AND

1. REMOVE AND INSTALL COVER

Using a T15 torx wrench, loosen and tighten the

Torque: 1.4 N–m(14 kgf–cm, 12 in.lbf)

2. DISCONNECT AND CONNECT 4–PIN AND 6–PIN

NOTICE: When installing, place the 4–pin connector's

cables into the cable guide.

3. REMOVE AND INSTALL ECU

Using T15 and T20 torx wrenches, loosen and tighten

the 5 screws.

Torque: 1.7 N–m(17 kgf–cm, 15 in.–Ibf)

NOTICE: There are 2 kinds of screw, so install a correct

screw into each hole.

4. PERFORM TEST DRIVE

(a) Drive for at least 20 seconds at 30 Km/h (119 mph).

(b) The ABS warning light may not light.

If the ABS warning light lights, read the diagnostic

trouble code.