Toyota Camry Manual page 222

AUTOMATIC TRANSAXLE –
TORQUE CONVERTER CLUTCH AND
DRIVE PLATE INSPECTION
1. INSPECT ONE–WAY CLUTCH
(a) Install SST into the inner race of the one–way clutch.
SST 09350–32014 (09351–32020)
(b) Install SST so that it fits in the notch of the converter
hub and outer race of the one–way clutch.
SST 09350–32014 (09351 –32020)
(c) With the torque converter clutch standing on its side,
the clutch locks when turned counterclockwise, and
rotates freely and smoothly clockwise.
If necessary, clean the converter and retest the clutch.
Replace the converter if the clutch still fails the test.
2. MEASURE DRIVE PLATE RUNOUT AND INSPECT
RING GEAR
Set up a dial indicator and measure the drive plate
runout.
If runout exceeds 0.20 mm (0.0079 in.) or if the ring
gear is damaged replace the drive plate. If installing a
new drive plate, note the orientation of spacers and
tighten the bolts.
Torque: 83 N–m (850 kgf–cm, 61 ft–lbf)
ASSEMBLY REMOVAL AND INSTALLATION
AX2–35