Toyota Camry Manual page 649

BO–98
BODY – SLIDING ROOF
ON–VEHICLE INSPECTION
INSPECT SLIDING ROOF GLASS ALIGNMENT
(a) Start the engine and check the operation time of the
sliding roof.
Operation time:
Approx.6 sacs.
(b) Check for abnormal noise or binding during operation.
(c) With the sliding roof fully closed, check for water
leakage.
(d) Check for a difference in level between the sliding roof
weatherstrip and roof panel.
Front end:
1 1 mm (0.039 0.039 in.)
Rear end:
0 1 mm (0 0.039 in.)
If the sliding roof does not operate:
(e) Remove the control switch cover.
(f) Remove the large screw inside.
NOTICE: Be careful not to lose the spring washer or shim.
(g) Manually operate the moon roof by inserting a special
crank–shaped screwdriver into the hole and turning
the drive shaft.
SLIDING ROOF ADJUSTMENT
1. REMOVE SLIDING ROOF GARNISHES
Before making adjustments, remove the left and right
sliding roof garnishes.
HINT: After adjustment, reinstall the sliding roof gar–
nishes.
2. TO ADJUST LEVEL DIFFERENCE
Adjust by increasing or decreasing the number of
shims between the bracket and sliding roof.