Toyota Camry Manual page 881

BRAKE SYSTEM – FRONT BRAKE(Single–Piston Type)
(c) Repeat (b) until the disc has been installed on the 3
remaining hub positions.
(d) If the minimum runout recorded in (b) and (c) is less
than 0.05 mm (0.0020in.), install the disc in that
position.
(e) If the minimum runout recorded in (b) and (c) is greater
than 0.05 mm (0.0020 in.), replace the disc and repeat
step 3.
(f) Install the torque plate and torque the mounting bolts.
Torque: 107 N–m (1,090 kgf–cm, 79 ft–lbf)
CALIPER ASSEMBLY
1. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO
PARTS INDICATED WITH ARROWS
2. INSTALL DUST BOOTS AND SLIDING PINS
(a) Using a 19 mm socket wrench and hammer, tap in 2
new dust boots into the torque plate.
(b) Confirm that the metal plate portion of the dust boot
fits snugly in the torque plate.
(c). Insert 2 sliding pins into the torque plate.
NOTICE: Insert the sliding pin with sliding bushing into
the bottom side.
3. INSTALL PISTON SEAL AND PISTON IN CYLINDER
BR–195