Toyota Camry Manual page 491

BE–172
No. Operation Method
Turn SET/COAST switch ON.
Turn RES/ACC switch ON.
Turn CANCEL switch ON.
Turn stop light switch ON.
(Depress brake pedal)
Turn parking brake
switch ON.
Turn park/neutral position switch
ON. (Shift to N or P position.)
Turn clutch start switch ON.
(Depress clutch pedal.)
Drive at 40 km/h (25 mph)
or higher.
Drive at 40 km/h (25 mph)
or below.
BODY ELECTRICAL SYSTEM
INPUT SIGNAL CHECK
Output of Code
1. (a) For check No. 1 – No.2
Turn the ignition switch on.
(b) For check No.3 – No.7
(1) Turn the ignition switch on.
(2) Shift to D position.
(e) For check No.8 – No.9
(1) Jack up the vehicle.
(2) Start the engine. (3) shift to D position.
2. Press the control switch to SET/COAST or RES/ACC posi–
tion and hold it down 1 or up 1.
3. Push the main switch on 2.
4. Check that the CRUISE MAIN indicator light blinks twice
or 3 times repeatedly after 3 seconds.
5. Turn the SET/COAST or RES/ACC switch oft.
6. Operate each switch as listed in the table below.
7. Read the blinking pattern of the CRUISE MAIN indicator
light.
8. After performing the check, turn the main switch oft.
HINT: When two or more signals are input to the ECU,
only the lowest–numbered code is displayed.
CRUISE MAIN Indicator Light
Blinking Pattern
– CRUISE CONTROL SYSTEM
Diagnosis
SET/COAST switch
circuit is norm al.
RES/ACC switch circuit
is normal.
CANCEL switch circuit
is normal.
Stop light switch circuit
is normal.
Par–king brake switch
circuit is normal.
Park/Neutral Position
switch circuit is normal.
Clutch switch circuit
is normal.
Speed sensor is normal.