Toyota Camry Manual page 262

MEASURE LINE PRESSURE
NOTICE:
Perform the test at normal operating fluid temperature 50–80
The line pressure test should always be carried out in pairs. One technician should observe the
conditions of wheels or wheel stoppers outside the vehicle while the other is performing the test.
Be careful to prevent the oil pressure gauge hose from interfering with the exhaust pipe.
(a) Warm up the transmission fluid.
(b) Remove the test plug on the transaxle case left side and connect the oil pressure gauge SST.
SST 09992–00094
(c) Fully apply the parking brake and chock the four wheels.
(d) Start the engine and check idling RPM.
(e) Keep your left foot pressed firmly on the brake pedal and shift into D position.
(f) Measure the line pressure when the engine is idling.
(g) Press the accelerator pedal all the way down. Quickly read the highest line pressure when engine
speed reaches stall speed.
(h) In the same manner, perform the test in R position.
AUTOMATIC TRANSAXLE – TROUBLESHOOTING
_
C (122–176
AX2–75
_
F).