Toyota Camry Manual page 868

BR–182
INSPECTION PROCEDURE
Check voltage between terminals Te and E1 of DLC2 or DLC1.
Check for open and short in harness and connector between ABS ECU
and DLC2 or DLC1, DLC2 or DLC1 and body ground (See page
Check and replace ABS ECU.
BRAKE SYSTEM – ANTI–LOCK BRAKE SYSTEM (ABS)
1. Turn ignition switch ON.
2. Measure voltage between terminals Tc and E1
of DLC2 or DLC1.
Voltage: 10–14 V
If ABS warning light does not blink even after Tc
and E 1 are connected, the ECU may be defective.
Repair or replace harness or connector.
IN–28
).