Toyota Camry Manual page 684

BODY – SEAT BELT
SEAT BELT INSPECTION
Emergency Locking Retractor (ELR) and
Automatic Locking Retractor (ALR) type
1. RUNNING TEST (INN SAFE AREA)
for all seat:
(a) Fasten the front seat belts.
(b) Drive the car at 10 mph (16 km/h) and make a very
hard stop.
(c) Check that the belt is locked and cannot be extended
at this time.
HINT: Conduct this test in a safe area. If the belt does
not lock, remove the belt mechanism assembly and
conduct the following static check. Also, whenever
installing a new belt assembly, verify the proper oper–
ation before installation.
2. STATIC TEST
for driver's seat (ELR):
(a) Verify that the belt locks when pulled out quickly.
(b) Remove the locking retractor assembly.
(c) Tilt the retractor slowly.
(d) Verify that the belt can be pulled out at a tilt of 15
degrees or less, and cannot be pulled out over 45
degrees of tilt.
If a problem is found, replace the assembly.
except for driver's seat (ALR/ ELR):
(a) Verify that the belt locks when pulled out quickly.
(b) Remove the locking retractor assembly.
(c) Pull out the whole belt and measure the length of the
whole belt.
Then retract the belt slightly and pull it out again.
(d) Verify that the belt cannot be extended further.
If a problem is found, replace the assembly.
(e) Retract the whole belt, then pull out the belt until 200
mm (7.87 in.) of belt remains retracted.
(f) Tilt the retractor slowly.
(g) Verify that the belt can be pulled out at a tilt of 15
degrees or less, and cannot be pulled out at over 45
degrees of tilt.
If a problem is found, replace the assembly.
BO–133