Toyota Camry Manual page 86

AUTOMATIC TRANSAXLE –
ON–VEHICLE REPAIR
VALVE BODY REMOVAL
1. CLEAN TRANSAXLE EXTERIOR
To help prevent contamination, clean the exterior of
the transaxle.
2. DRAIN TRANSAXLE FLUID
Remove the drain plug with SST, and drain the fluid
into a suitable container.
SST 09043–38100
3. REMOVE OIL PAN AND GASKET
NOTICE: Some fluid will remain in the oil pan.
Remove all pan bolts, and carefully remove the pan
assembly discarding the gasket.
4. EXAMINE PARTICLES IN PAN
Remove the magnets and use them to collect any
steel chips. Look carefully at the chips and particles in
the pan and on the magnet to anticipate what type of
wear you will find in the transaxle.
Steel (magnetic): bearing, gear and plate wear
Brass (non–magnetic): bushing wear
5. REMOVE OIL STRAINER AND APPLY TUBE BRACKET
(a) Remove the 3 bolts and the oil strainer.
NOTICE: Be careful as oil will come out of the strainer
when it is removed.
(b) Remove the 2 bolts and the apply tube bracket.
6. DISCONNECT SOLENOID CONNECTORS
ON–VEHICLE REPAIR
AX1–13