Toyota Camry Manual page 630

BODY – WINDSHIELD
9. COAT CONTACT SURFACE OF BODY WITH
PRIMER "M"
Using a brush, coat the contact surface on the body
with Primer M.
NOTICE:
Let the primer coating dry for 3 minutes or more.
Do not coat to the adhesive.
Do not keep any of the opened primer M and G for
later use.
10. COAT CONTACT SURFACE OF GLASS WITH
PRIMER "G"
(a) Using a brush or sponge, coat the edge of the glass
and the contact surface with Primer G.
(b) Before the Primer dries, wipe it off with a clean shop
rag.
NOTICE: Let the primer coating dry for 3 minutes or
more.
11. MIX ADHESIVE COATING
NOTICE:
Be sure that installation of the moulding is finished
within usable time. (See step 3 on page BO–9)
The mixture should be made in 5 minutes or less.
(a) Thoroughly clean the glass plate and putty spatula
with solvent.
(b) Thoroughly mix 500 g (117.64 oz.) of the main agent
and 75 g (2.65 oz.) of the hardening agent on a glass
plate or like object with a putty spatula.
12. APPLY ADHESIVE
(a) Cut off the tip of the cartridge nozzle. Fill the cartridge
with adhesive.
(b) Load the cartridge into the sealer gun.
(c) Coat the glass with adhesive as shown.
BO–79