Toyota Camry Manual page 593

BO–42
BODY – REAR DOOR
POWER WINDOW MOTOR REMOVAL AND
INSTALLATION
1. REMOVE POWER WINDOW MOTOR
(a) Remove the cover plate by bending its tabs.
(b) Pull out the drum while detaching the cable guide out
from the motor.
HINT:
Pull out the drum and the cable guide evenly
without tilting the drum.
Handle the window regulator carefully so that the
cable does not get detached.
Do not pry above parts with a screwdriver.
2. INSTALL POWER WINDOW MOTOR
(a) Install the motor by fitting the shaft of the motor into
the window regulator drum.
HINT:
If the shaft does not fit properly into the drum,
slowly move the window glass bracket by hand
to turn the drum.
While turning the drum, make sure that it does
not detach away from the cable guide.
(b) Reattach the cover plate.
(c) Use a plastic hammer to bend the cover plate tabs.
HINT:
Do not strike on the tabs with excessive force.
Attach the cover plate firmly onto the motor to
eliminate any looseness.
In case the cable detaches from the drum, it can be
reattached as follows:
(a) Attach the drum, cable guide, and regulator as shown.