AX1–110
TE1 Terminal Circuit
CIRCUIT DESCRIPTION
The ECM displays diagnostic trouble codes using the O/D OFF indicator light when terminals TE1
and E1 of the DLC2 or DLC1 are connected.
DIAGNOSTIC CHART
Check voltage between terminals TE1 and E1
of DLC2 or DLC1.
Check harness and connector between ECM
and DLC2, DLC1 and body ground (See
page IN–31).
Check and replace ECM.
WIRING DIAGRAM
AUTOMATIC TRANSAXLE
–
TROUBLESHOOTING
Proceed to next circuit inspection
shown on matrix chart (See page
AX1–68).
Repair or replace harness or con–
nector.