Toyota Camry Manual page 884

BR–198
BRAKE SYSTEM – FRONT BRAKE(2–Piston Type)
2. INSPECT PAD LINING THICKNESS
Check the pad thickness through the caliper inspec–
tion hole and replace the pads if it is not within the
specification.
Minimum thickness:
1.0 mm (0.039 in.)
3. LIFT UP CALIPER
(a) Hold the sliding pin on the bottom and loosen the
installation bolt.
(b) Remove the installation bolt.
(c) Lift up and suspend the caliper.
HINT: Do not disconnect the flexible hose from the
brake caliper.
4. REMOVE FOLLOWING PARTS:
(a) 2 anti–squeal springs
(b) 2 brake pads
(c) 4 anti–squeal shims
(d) 4 pad support plates
(e) Pad wear indicator
5. CHECK DISC THICKNESS AND RUNOUT
(See page BR–33)
6. INSTALL PAD SUPPORT PLATES
Install the 4 pad support plates.