Toyota Camry Manual page 223

AX2–36
AUTOMATIC TRANSAXLE –
3. MEASURE TORQUE CONVERTER CLUTCH SLEEVE
RUNOUT
(a) Temporarily mount the torque converter clutch to the
drive plate. Set up a dial indicator.
If runout exceeds 0.30 mm (0.0118 in.), try to correct
by reorienting the installation of the converter. If ex–
cessive runout cannot be corrected replace the torque
converter clutch.
HINT: Mark the position of the converter to ensure
correct installation.
(b) Remove the torque converter clutch.
TRANSAXLE INSTALLATION
1. INSTALL TORQUE CONVERTER CLUTCH IN TRA–
NSAXLE
If the torque converter clutch has been drained and
washed, refill with new ATF.
Fluid type:
ATF DEXRON
2. CHECK TORQUE CONVERTER CLUTCH INSTALLA–
TION
Using calipers and a straight edge, measure from the
installed surface to the front surface of the transaxle
housing.
Correct distance:
More than 13.7 mm (0.539 in.)
ASSEMBLY REMOVAL AND INSTALLATION
II