Toyota Camry Manual page 249

AX2–62
DIAGNOSTIC TROUBLE CODE CHART
If a diagnostic trouble code is displayed during the diagnostic trouble code check, check the
circuit listed for that code in the table below and proceed to the page given.
DTC No.
Output Speed Sensor Circuit Malfunction
P0720
(for Electronically Controlled Transaxle)
P0750 Shift Solenoid A Malfunction
Shift Solenoid A Electrical
(Shift Solenoid Valve No.1 j
P0753
Shift Solenoid B Malfunction
P0755
(Shift Solenoid Valve No.2)
Shift Solenoid B Electrical
(Shift Solenoid Valve No.2)
P0758
Shift Solenoid E Malfunction
P0770
(Shift Solenoid Valve SL)
Shift Solenoid E Electrical
(Shift Solenoid Valve SL)
P0773
"NC2" Revolution Sensor Circuit Malfunction
P1705
(Direct Clutch Speed Sensor)
Shift Solenoid Valve SLN Circuit
P1765
(For Accumulator Back Pressure Modulation)
P1780
Park/neutral Position Switch Malfunction
AUTOMATIC TRANSAXLE
Detection Item
– TROUBLESHOOTING
Diagnostic Trouble Code Detecting Condition
When DTC No. P0500 is detected
During normal driving the gear required by the ECM
does not match the actual gear.
(2 trip detection logic)
Open or short in shift solenoid A circuit.
Same as for DTC No.P0750
Open or short in shift solenoid B circuit
Lock–up does not occur when driving in the lock–up
range (normal driving at 80 km/h (50 mph). Or lock–up
remains ON in the lock–up OFF range.
(2 trip detection logic)
Open or short in shift solenoid E circuit for 1 time.
(2 trip detection logic)
Output of direct clutch speed sensor (NC2) is 300 rpm or
less under condition a) or b)
a) Vehicle speed: 32 km/h (20 mph) or more
b) Park/neutral position switch: OFF
(2 trip detection logic)
After the engine is warmed up, the current flow to the
shift solenoid valve SLN is 0.2 A or less for at least 1
second under condition a) or b)
(2 trip detection logic)
a) Engine speed: 500 RPM or more
b) Park/neutral position switch: ON
(P or N position)
Two or more switches are ON simultaneously for 'N', '2'
and 'L' position.
(2 trip detection logic)
–––––––
When driving under condition a) and b) for 30 seconds or
more the park/neutral position switch is ON (N position).
(2 trip detection logic) a) Vehicle speed: 44 mph (70 km/
h) or more
b) Engine speed: 1,500–2,500 rpm