Toyota Camry Manual page 287

AX2–100
INSPECTION PROCEDURE
Measure resistance between S 1 or S2 terminals of ECM connector and
body ground.
Check harness and connector between ECM and automatic
transaxle solenoid connector.
AUTOMATIC TRANSAXLE –
Disconnect the solenoid connector on the
automatic transaxle.
Check harness and connector between S 1 and S2
terminals of ECM connector and 3 terminals of
solenoid connector.
There is no open and no short circuit.
TROUBLESHOOTING
Measure resistance between S 1 or S2 terminals of
ECM connector and body ground.
Resistance: 10–16 9
Replace ECM.
Repair or replace harness or connector.