Toyota Camry Manual page 390

BODY ELECTRICAL SYSTEM
LOW OIL PRESSURE WARNING LIGHT
INSPECTION
INSPECT LOW OIL PRESSURE WARNING LIGHT
(a) Disconnect the connector from the warning switch
and ground terminal on the wire harness side connec–
tor.
(b) Turn the ignition switch ON, check that the warning
light lights up.
If the warning light does not light up, test the bulb or
inspect wire harness.
LOW OIL PRESSURE WARNING SWITCH
INSPECTION
INSPECT LOW OIL PRESSURE WARNING SWITCH
(a) Check that there is continuity between terminal and
ground with the engine stopped.
(b) Check that there is no continuity between terminal
and ground with the engine running.
HINT: Oil pressure should be over 29 kPa (0.3 kgf/
2
cm , 4.3 psi)
If operation is not as specified, replace the switch.
BRAKE FLUID LEVEL WARNING LIGHT
INSPECTION
INSPECT BRAKE WARNING LIGHT
(a) Disconnect the connector from the brake fluid warn–
ing switch.
(b) Release the parking brake pedal.
(c) Connect terminals on the wire harness side of the
level warning switch connector.
(d) Start the engine, check that the warning light lights
up.
If the warning light does not light up, test the bulb or
wire harness.
– COMBINATION METER
BE–71